MEASURING
PLASMA or LCD MONITORS

measuring your screen is dead easy, but
please do recheck your dimensions to
ensure a perfect case & fit!

EASY TIP: Push your LCD/PLASMA next to a wall takes
a lot of recheck + guess work....you can measure from the
WALL to the front of the screen etc = easy!

always close popups
 

1. Don't trust website, brochure or ANY manufacturers literature
2. It's easy! However PLASMA & LCD panels require PRECISE dimensions.
3. Check for any protrusions such as feet, knobs front, cable lugs rear etc
4.Don't add margins [eg: a fill mm's extra!]

 Measure precise, measure "sober"! Recheck!
Corporations, please do NOT delegate this job to juniors
or people "without basic mathematical skills" [polite, aren't we!]
 

RED = MUST BE PRECISE within +/- 2mm to ensure a perfect fit

D1 = Overall depth of stand/monitor
D2 = Thickness of Screen
D3 = front of stand to front of monitor
W1 = overall width (check top, middle & lower panel to make sure they're the same!
W2 = stand width
W3 = Width till Flat Edge [If Applicable]
H1 = overall height
H2 = floor to bottom of monitor

all dimensions are critical. we can't make a case without one of them.